Flowflex SARS-CoV-2 Antigen Rapid test

New: self tests suitable for direct sales to private individuals. This rapid test has an exemption from the Ministry of Health, Welfare and Sport for use by private individuals. This makes it the first official self-test in the Netherlands!

The Flowflex rapid test makes it possible to identify persons infected with the Coronavirus. The antigen test takes a sample from the inside of the nose using a cotton swab. The advantage of this test is that the cotton swab does not have to go far in your nose. In addition, you will receive the results within approximately 15 minutes!

The COVID-19 rapid test has a sensitivity of 97.1% and a specificity of 99.5%. This makes the Flowflex SARS-CoV-2 Rapid Antigen Test Nasal the first and most reliable self test in the Netherlands for private individuals!

The Flowflex SARS-CoV-2 Antigen Rapid Test has been approved by the Dutch government and is therefore the first official self-test in the Netherlands. Suitable for use by both medical personnel and individuals. One carton contains 240 individually packaged tests.

Photos

Nice to know

Certified in the Netherlands

All rapid tests are approved by the government

Fast results

Results are shown within approx. 15 minutes

Instructions

Sample Collection

Gently insert the soft tip of the swab 2 cm into one nostril until you feel a little resistance.
Slowly rub the cotton swab over the inner wall of the nostril 4 times in a circular motion for 15 seconds. Be careful not to apply pressure.
Repeat the same procedure with the same cotton swab in the other nostril.
Pay attention! It is important that the sample is taken from both nostrils with the same swab.

Treatment of the sample

The swab is then placed in an extraction buffer tube.
Move the swab back and forth more than 10 times while squeezing the buffer tube. The soaking time of the swab is less than 15 seconds.
Remove the swab from the tube and, while doing so, squeeze the tube so that enough liquid is extracted from the swab.
Pay attention! Failure to squeeze the tube may cause incorrect test results due to too much buffer in the swab.
Finally, press the spout cap firmly onto the tube.

Test procedure

Place the test device on a flat surface and add 4 drops of the extracted sample to the sample well of the test cassette.
See the results after about 15 to 30 minutes.
Pay attention! Waiting longer than 30 minutes can lead to a risk of incorrect results.

What does the result of the Corona test say?

Positive: Two color bands appear in the observation window. That is, a red or magenta line appears at the position of the quality control line (C line) and the detection line (T line) (as shown in Result 1), indicating that the test result of SARS-CoV-2 antigens in the sample is positive.
Negative: A red or magenta line appears at the quality control line (C-line) position in the observation window, and no line appears at the test line (T-line) position (as shown in Result 2), indicating that the test result of the SARS-CoV-2 antigens in the sample is negative, or the concentration is below the detection limit of the kit.
Invalid: No line appears in the position of the Quality Control Line (Line C) in the Observation Window (as shown in Result 3), indicating that the test is invalid and the sample must be re-collected and retested.